User manual to Remote control

This description applies to the Remote control Model: SRC-4513/4515

Programming (or learning) STB remote control means assigning for its buttons certain functions of other devices (usually, TV) Remote Control. For programming, only dedicated STB remote control buttons can be used (blue colored - see description below).

To program the STB's buttons do the following:

• Press left (blue) button On/Of and button A/V at the same time and hold them for 2 seconds. When green light of left «On/Off» key stops blinking and lights steadily, it means that RC is ready to learn.
• On STB's RC, press key that you want to «teach» — green light will start blinking.
• Place the infrared LEDs of both RCs opposite to each other.
• On TV's RC, press key which function you wish to assign to STB's RC. Hold down for 2 seconds.
• After the green light double blinks, you may continue programming other keys.
• Repeat the procedure described above for all keys you want to program to control external devices.
• Press On/Off and A/V keys to save the programmed data; green light should fade off.

Using programmed STB remote control buttons

For example, if you want to turn on/off the TV from STB's RC, you must assign the On/Off button of TV's RC to one of programmable STB remote buttons (for example, A/V button). Then, to turn the TV off or on, you need to send STB's RC to TV and press A/V button.

Reset STB remote to the factory settings

Press SETUP and OK keys at the same time and hold for 2 seconds. Red LED will blink 5 times. Reset is done (all programmed sections of STB remote is reset).

Remote controls appearance